User's Manual

ManualsBrandsSHENZHEN HUBSAN INTELLIGENT ManualsElectronicsX4 STAR FPV

2016 Hubsan

Home Point: It is recorded when armed the motors with no less than 6 GPS satellites.

CONDITIONS WHICH ACTIVATE THE FAILSAFE MODE

(1) Transmitter is powered off.

(2) The flight distance is beyond the range of the transmitter’s signal transmission.

(3) The transmitter’s signal was interrupted by some other strong electronic interference.

To ensure that the X4 can return safely to its home point when signal is lost, fly the

X4 in safe flight area.

If the quantity of GPS satellites drops below six for more than 20 seconds while the

X4 is returning home, the X4 will descend automatically.

The X4 can not avoid obstacles automatically while in failsafe mode.

When the power is low, please land the quadcopter in case of any damges

RTH only works when the quadcopter and tranmitter have more than 6 GPS satellites.

Summary of content (11 pages)

PAGE 1
CONDITIONS WHICH ACTIVATE THE FAILSAFE MODE (1) Transmitter is powered off. (2) The flight distance is beyond the range of the transmitter’s signal transmission. (3) The transmitter’s signal was interrupted by some other strong electronic interference. Home Point: It is recorded when armed the motors with no less than 6 GPS satellites. To ensure that the X4 can return safely to its home point when signal is lost, fly the X4 in safe flight area.
PAGE 2
7. TRANSMITTER Quad copter’s battery capacity Recording time Transmitter’s Record/Camera SD Card battery capacity status X4 7.3V Voltage Tilt Angle Pitch Angle Nose Orientation 00:23:59 0.3m/s 1.5m 0m R 0 P 0 H 247 Speed Height Distance GPS Signal Quad copter’s GPS Transmitter’s GPS X4 GPS 6 GPS 6 N22.7914931 E:114.0479740 N:22.7914650 E:114.
PAGE 3
7.1 INPUT KEY FUNCTION S/N (1) (2) 1 2 Mode/ Control MODE 1 Throttle/Aileron Stick Function Push the stick forward or backward and the quadcopter will ascend or decend; Push the stick left or right and the quadcopter will fly left or right. Push the stick forward or backward and the quadcopter will fly MODE 1 Elevator/Rudder Stick forward or backward;Push the stick left or right and the quadcopter will rotate counter clockwise or clockwise.
PAGE 4
7.2 INSTALL THE TX BATTERY PUSH PUSH Remove the cover Install 4 x AA batteries according to the correct polarities ● Do not mix old and new batteries ● Do not charge non-rechargeable battery. Close the cover ● Do not mix different types of batteries 7.3 REVERSING CHANNEL SETUP If you would like to reverse any of the stick functions due to personal preference then follow the instructions below. Be aware that it will change the controls back to front.
PAGE 5
0:08:49 M2 0:08:49 MAIN MENU Set Reverse Set Sensitivity 5.8G Frequency Set Manual Fly When no GPS Show Version Exit M2 SET SENSITIVE Exit Expert mode Elevator : 100 Aileron : 100 Rudder : 100 Sensitivity default setting is in Expert Mode. 7.
PAGE 6
8. TRANSMITTER CALIBRATION Mode 2: Push both sticks to the upper left corner and power on the transmitter simultaneously until “Calibrate Stick Mode 2” displays on LCD, rotate both sticks in circles for three times, then release both sticks, press any trim for 1.5 seconds until the LED on the transmitter turns into solid green which indicates a successful calibration.
PAGE 8
Motor B Motor A GPS Module 5.8 GHz Transmission Module Screw（PB1.4*3) Signal Isolation Membrane Upper Body Shell Lower Body Shell Battery Compartment Lampshade Li-Po Battery Camera Module Motor Shaft B Motor Shaft A Shaft Sleeve Motor Holder Rotary Gear 2 2 1 1 4 1 1 1 1 4 1 1 2 2 8 4 4 2 2 2 2 1 1 2 8 8 8 2 2 1 1 Propeller A Propeller B Blue LED Red LED Compass Module Main Control Board Screw（PA1.4*4) Screw（PA1.4*5) Screw（PA1.4*6) Screw（PA2.0*5) Screw（PM1.4*5) Screw（PM1.4*5) 5.8G Attenna 2.
PAGE 9
H507D TROUBLESHOOTING 1. Cannot bind！ ① Check if the quadcopter and transmitter are powered on or not. ② Rebind the quadcopter and transmitter, please refer to the procedures instructed by point 5.3 in the manual. 2. Cannot arm the motors！ ① Check if the compass calibration is completed or not. ② Make sure the Home switch on transmitter is off. ③ Calibrate the transmitter. 3. No GPS Signal！ Make sure it’s for outdoors flight, and the flight environment should be open without tall buildings. 4.
PAGE 10
FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 11
H507A TROUBLESHOOTING User manual is subject to change without prior notice due to unforseen product upgrades. WWW.HUBSAN.COM VERSION 1.