User's Manual

2. QUAD COPTER MOTOR LED INDICATOR

3. QUAD COPTER BATTERY

Indicator Status:

Front LED: is blue; Back LED: is red.

1.Power on: 4 LED indicators blink simultaneously

2.Compass Calibration:

1）Horizontal calibration: 4 LED indicators blink circularly.

2）Vertical calibration: 4 LED indicators blink alternately.

3.Quadcopter Calibration：4 LED indicators blink slowly.

GPS Flight: 4 LED indicators remain lighted.

GPS Return : 2 front LED remain lighted, and 2 back LED blink

slowly.

Low Voltage: 2 front LED remain lighted, and 2 back LED blink quickly.

Disconnection: When the quad is out of control, 2 front LED blink alternately, and

2 back LED remain lighted.

3.1 INTRODUCTION

The quad copter battery is a rechargeable Li-Po battery with 550mAh

capacity and 7.6V voltage.

The battery should only be charged with the HUBSAN charger to avoid

overcharge.

3.2 INSTALL THE BATTERY

Push the battery into the battery

compartment correctly.

3.3 CHARGING

Connect the battery to the USB charger, then connect the USB charger to

USB devices, such as a computer or mobile power charger (5V，1A).

The USB LED indicator blinks in red when charging, and remain lighted after the

battery is fully charged, then please unplug the charger and battery

Charging time: around 200 mins.

Please make sure the battery is fully charged before first time use.

Please fully charge the batteries to avoid loss of control due to low voltage.

4 PROPELLER

4.1 Introduction

The quad is equipped with 6.95" propellers that are marked with A and B.

Propellers are consumables, please replace with new ones if there is any damage.