User's Manual

3. QUAD COPTER BATTERY

3.1 INTRODUCTION

The quad copter battery is rechargeable with 2700mAh capacity and 7.4V voltage.

The battery should ONLY be charged with the HUBSAN charger to avoid overcharge.

3.3 CHARGING

Connect the battery to the balance charger and wall charger. The balance charger

indicator is solid red when charging and turns to solid green when the battery is fully charged.

It takes around 210 minutes to get the battery fully charged.

3.2 INSTALL THE BATTERY

Push the battery into the battery compartment

correctly and connect the battery plugs with the

correct polarity.

Close the battery compartment cover.

7.4V 2700mAh 10C

2. QUAD COPTER MOTOR LED INDICATOR

Please fully charge the batteries to avoid loss of control due to low voltage.

Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the local regulations.

Indicator Status:

1. Power on: 4 white LED indicators blink simultaneously every 1.5 seconds.

2. Compass Calibration:

1). Horizontal calibration: 4 red LED indicators blink circularly.

2). Vertical calibration: 4 green LED indicators blink circularly.

3. GPS Flight: 4 LED indicators remain blink. .

4. GPS Return : 2 front LED blink in white, 2 back LED blink in blue.

5. Altitude Hold: 2 front LED blink in white, 2 back LED blink in yellow.

6. Position Hold: 2 front LED blink in white, 2 back LED blink in green.

7. Low Voltage: 2 front LED blink in white, 2 back LED blink in red.

8. LED indicators can be turned off by long pressing the lower Throttle Trim on transmitter.