User's Manual

HUBSAN 11.5V
Set reverse +
Set sensitive +
Plane type Air plane
Expert mode Yes
Stick mode 2
5.8G frequence
Hold down the ENTER key for 1 second to enter setting status, move the arrow to 5.8G FREQUENCE
with up/down key, press the ENTER key again and select the frequency you need with up/down key,
hold down the EXIT key for 2 seconds to conrm and exit.
12 SPY HAWK
H301S
11 SPY HAWK
H301S
www.hubsan.comwww.hubsan.com
HUBSAN
11.5V
7.6V
5
N22.7911066 E114.0477988
M2 0:04:47
R
X
GPS
H+49°
R+7°
P+3°
S0. 0
0m
+0.0m
/
m
s
Dist
A
L
T
7
GPS
HUBSAN 11.5V
Set reverse +
Set sensitive +
Plane type Air plane
Expert mode Yes
Stick mode 2
5.8G frequence
5725 MHz
7
GPS
Make sure the plane installed correctly, the lipo battery is full charged and the transmitter loaded
with 8 x AA batteries.
6.1 Bind the transmitter and the plane
Power on the transmitter, then the plane; the transmitter will show the lipo battery voltage and other
values as below shows. If no value shows, need to bind the transmitter to the plane, hold down the
ENTER button, power on the transmitter, wait the LCD screen shows “Bind to plane”, then power on
the plane.
6.HOW TO LAUNCH
Level calibration method:
Hold the Throttle stick to the full down position and move the Rudder stick to the lower right position.
Quickly move the Aileron stick to the left and right repeatedly until the Red LED and Green LED lights
on the Main Wing blinks two times, indicating successful calibration.
6.2 Check everything before ight
6.2.1 Check the plane’s horizon level
Lay the plane on a level surface, see the value of Pitch(P) and Roll(R), the normal range should in 5°to
-5°, if it is not in this range, the plane need to do level calibration.
Check the rudder and the aileron servo, make sure they are in the lines with the Main Wing, adjust
push rod if needed. All plane will be regulated in the proper position factory defaulted.
6.2.2 Check the Electronic compass
Hold the plane, keep it levelly, then spin the plane slowly to watch the Head(H) value, it will change
from 0°to 360°continuouslyandevenly. When the plane point to Star North,the value will be 0°, or
the compass need to do calibration.
Compass calibration method:
Hold the Rudder Stick in the down left, quickly move the Aileron Stick to the left and right until the
Red LED and Green LED lights blinks alternately, indicating the the calibration is in process. In this
moment, levelly spin the plane slowly for a 360°, and vertically spin the plane for a 360°to wait the
LED stop blinking, indicating successful calibration.
6.2.3 Check the GPS signal
Outdoors, after the plane power on for 2-5 minutes, the GPS value will be change into 6 or above 6,
please wait until then to y the plane.
Bind to plane