User's Manual

(MODE 1 transmitter)
Push the left joystick to the top on the left, and the right joystick to the top on the right, keep them
in this position and then turn on the transmitter, the LCD screen will show “CALIBERATE STICK”,
Move the joysticks in a circling motion about 3 times, and then release the joystick and press “EXIT”
key to save and exist.
(MODE 2 transmitter)
Push the two joysticks to the top on the left and keep them in this position, and then turn on the
transmitter, the LCD screen will show “CALIBERATE STICK”, move the joysticks in a circling motion
about 3 times, and then release the joystick and press “EXIT” key to save and exist.
(MODE 1 transmitter) (MODE 2 transmitter)
Notice:
>Do not mix old and new batteries
>Do not mix dierent types of batteries
>Do not charge non-rechargeable battery.
Open the cover Take out the holder
According to the correct
polarities,install 8 x AA battery
Insert the plug into Return the holder Fasten the screw
the power jack back to the compartment
4.3 Battery mounting
4.4 Transmitter Stick Calibration
7.1.1 Remove the canopy to
locate the SD card slot
Note:
Always turn OFF the Air Plane's power before inserting or removing the SD card.
Always stop the video recording function and power o the battery rstly, and then you
can take out the SD card.
Try to avoid letting the Air Plane rest for any longer than 2 minutes, otherwise the camera module will
OVERHEAT! This will result the screen on the remote going dark and poor quality recordings.
There are cooling vents on the canopy to keep the camera module below 60 C. DO NOT cover this
vent or prevent the air ow into the camera compartment.
WARNING:
7. VIDEO RECORDING
14 SPY HAWK
H301S
09 SPY HAWK
H301S
www.hubsan.comwww.hubsan.com
7.1.2 Insert the SD card
Note:Avoid removing the SD
card and re-inserting again
too quickly otherwise the
recording module will not
work properly
7.1.4 When the red dot
become
the recording logo, indicating
recording stopped
7.1.5 You can start/stop
recording by either pressing
the button next to the SD
card slot on the Air Plane or
using the remote
7.1.6 Using Enter button on
Remote controll to stop/start
recording
7.1.3 Recording time：
The red dot blinking,
indicating recording started,
and the video recording time
will start to count
Press ‘Enter’ button
to switch ON/OFF
video recording
HUBSAN
8.0V
7.3V
+165
96
3
Stabili Mode
N00.0000000 E000.0000000
00:00:00
1080FHD
00:00:00
R
X
GPS
H+251°
R+16°
P+0°
S0. 0
0m
+0.0m
/
m
s
Dist
A
L
T
M2 0:04:47
HUBSAN
8.0V
7.3V
+180
96
0
Stabili Mode
N00.0000000 E000.0000000
00:00:00
1080FHD
00:00:00
R
X
GPS
H+254°
R+17°
P+0°
S0. 0
0m
+0.0m
/
m
s
Dist
A
L
T
M2 0:04:47