User's Manual

H002 TRROUBLESHOOTING

1. Transmitter and Quadcopter can not pair

Throttle position needs to be fully down. Please do not move any sticks or trims

during initial power-on binding.

2. Gyro not Working Well

1）Battery voltage is too low；

2）Re-bind；

3）Land the quadcopter on the ground with the throttle stick fully down, take

off again after 3 seconds.

3. Unable to Flip

Li-Po power is too low, re-charge the battery.

4. Quadcopter is shaking or making noise during flight

Check if motors, bodyshells and propellers are all properlly positioned or not;

Check if motors and propellers damaged or not.

5. Propellers work well, but cannot take off

Improper installation of the propellers. Check if the propeller A and propeller B

installed correctly or not (As shown in below picture)

（顶视图 )

（低视图 )

蓝色蓝色

蓝色

前

蓝色红色

红色白色黑色

6. One or more motors stop working

1）Check if propellers squeeze motors;

2）Resolder if there is any broken motor connections.

3）Replace the motor.

7. Drifts

Make calibration as instructed below:

1）Make sure propellers, motors and quadcopter all in good condition, and the

battery is connected correctly with full power, bind the quadcopter and remote

controller

2）Calibrating Procedures:

Mode 2: Push the left stick to the most right corner, and move the right stick

left to right quickly, the 4 LED indicators on quadcopter will blink alternately,

calibration succeeded when the indicators stop blinking.

Mode 1: Push the left stick to the most right corner, put the right stick to the

lowest and move left to right quickly, the 4 LED indicators on quadcopter will

blink alternately, calibration succeeded when the indicators stop blinking.