User's Manual

User manual
Enjo
y it.
Safety Precauons
R
ead these safety instrucons before using your device and
store them for possible future reference.
•The device should not be exposed to dripping or splashing
water.
•CAUTION: Danger of explosion if baery is incorrectly
replaced or not replaced by the same type or equivalent.
•The baery should not be exposed to excessive heat
such as sunshine, fire or similar.
•Different types of baeries, new and used baeries should
not be mixed.
•The baery must be installed according to the polarity.
•If the baery is worn, it must be removed from the product.
•The baery must be disposed of safely. Always use the
collecon bins provided (check with your dealer) to protect
the environment.
• The baery can’t be replaced by the user, but only by the
maker of this product, the aer sales department or a
qualified person.
Modelo :H33T
Bluetooth Version: V 5.0
Bluetooth Range: 10meters
Playback me: 2-3 hours
Charging me: 1 hour
Standby me: 100 hours
Accessories:
1*user manual
1*type-c charging cable
The headset is automacally turned on aer it is removed
from the charging box.At the same me, the voice prompts
"turn on" (or press both headphones for 1.5 seconds).The
lights are red and blue.Put the earplug into the charging box
and close it (or press the two earplugs for 5 seconds). The
right flashes red .
1) when two earplugs are removed from the charging case,
they are automacally paired and the sound informaon is
"connected" between the two earplugs.
2) open the bluetooth of the mobile phone, search for
(H33T), and click connect. Aer successful connecon, the
voice message "connected" will be displayed, and the
indicator light will flash blue every 5 seconds.
3) when the two earplugs are removed again, they are
automacally connected to the phone.
To
uch Le ear pod Right ear pod
Long Touch Power on/off Power on/off
Single Touch
Play/pa use answer/End a
call
Play/pa use answer/ End
a ca ll
Medium Touch(2 seconds)
Previous track Next track
funcon Touch
reject a call Call status Double Touch
Redial last number Double Touch
whe
n earbuds in low in power ,sound message "lower
baery plaease change", The light will flash red every 5
seconds.At this me,please put earbuds into the charging
box to charging.the LED OF earbuds lighng red,and
lighng off aer full charged,the led light of charging box
lighng blue, and light off when earbuds full charged.
when the power is lower of the charging box,the led light
and flash with blue,At this me,please ues the micro USB
cable,connect the charging box and the other an connect
to computer or other charger for charging,when charging,
the led light and flash with blue,aer full charge, and light
off when earbuds full charged.
Specific
aons
T
urning on/off /pairing
Ear pod touch funcon
Charging
FCC Statement
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.