User's Manual
23. Kit32‐50400‐50
2IndoorOmni3dbiAntennas&50’400CoaxialCable&a50Ohm2‐waysSplitter
24. Kit33‐50400‐75
3IndoorOmni3dbiAntennas&50’400CoaxialCable&a75Ohm3‐waysSplitter
25. Kit34‐50400‐50
4IndoorOmni3dbi
Antennas&50’400CoaxialCable&three50Ohm2‐waysSplitters
5 TROUBLESHOOTING
The LED alarm lights represent the status of the booster on each
frequency. When the lights are green the device is operating normally
meaning that it is not experiencing any oscillation (feedback) and it is
boosting the signal at maximum power. When the LED lights begin to
change color from green
to orange to red, it means that particular
frequencyisexperiencingsomeoscillation(feedback).
If the oscillation is excessive the booster will shut down for that
particular frequency. Thebooster will still work for the other frequency
onamulti‐bandbooster.
Oscillation is caused when the indoor (distribution) antenna
sends a
signal back into the outdoor (signal) antenna. Similar to a PA system,
when the microphonegets too close to the speaker it causes feedback .
This will occur if your antennas are too close together, or the indoor
antenna is pointed at the outdoor antenna. Make sure you have
adequateseparationandsometypeofshieldingbetweentheantennas
(Usuallyyourrooforacementwallisgoodenough).