User Manual

3.7 Install your cellular booster
Install the cellular booster in a location that is properly ventilated and not
exposed to excessive heat, moisture and/or direct sunlight. The optimal area
would be on a wall located near a power outlet.
It should be mounted in an easily accessible area so it’s easy to perform
general maintenance with the coaxial cable connections, dip switch settings
and power adaptor.
Make sure all cables and antennas are securely connected before
commissioning the system.
3.8 Power up your cellular booster
Once all the Following precautions have been taken, power on the cellular
booster.
1. Verify that you have left at least 20 feet of vertical separation space between the
indoor and outdoor antennas.
2. Never point the front of the yagi donor (outdoor) antenna towards the inside of
the server (outdoor)antenna.
3. Verify that the supplied coaxial cables from both the donor (outdoor) antenna
and the server (outdoor)antenna are properly connected to the cellular booster
before powering it up.
4. Carefully plug in the supplied power adaptor into the back of the cellular booster
where it is marked ‘power’ and connect the other end to a power outlet.
The LED indicator marked power should light up green.