User's Manual

Common Faults
6.1 Faults Description
Faults Possible Reasons Solutions
Can not charge
Charge pin didn’t touch well of cleaner
and charge station
Keep Charge pin touch well of cleaner
and charge station
The indicated light of charge station did
not work ，charge station didn’t connect
with power .
Check the adopter and charge stations,
the plug connect well. The indicated
light of charge station keep light
Cleaner can not
work well
Cables or carpet hinder the wheel go
forward
Pls help to clean the wheel
Suction trouble Clean the suction motor
Wheel can not run well Clean the wheel set
Middle brush in trouble Clean the middle brush
Back to charge
station even
didn’t finish
clean
Cleaner back to charge station since low
power
Charge the cleaner
Controller cannot
work （controller
can control in the
distance of 5m ）
Low power Charge the battery of controller
Turn off Cleaner or Low power Turn on Cleaner or charge
Infrared sensor is hided by dust Clean the bumper
There are another device disturb the
infrared signal
Avoid the device disturb the infrared
signal
27