User's Manual

FCC Warnning:

This equipment has been tested and found to comply with the limits for a Class B digital device,

Pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer

could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:(1)This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Specific Absorption Rate (SAR) information:

This Device meets the government's requirements for exposure to radio waves. The guidelines

are based on standards that were developed by independent scientific organizations through

periodic and thorough evaluation of scientific studies.The standards include a substantial safety

margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure

Information and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of

tissue. Device types: Device has also been tested against this SAR limit. This device was tested

for 0 mm for body-worn and 10mm for face up position respectively between the unit and the

body of the user. To maintain compliance with FCC RF exposure requirements, use accessories

that maintain a 10 mm for body-worn and 10mm for face up position respectively between the

user's body and the back of the Device. The use of belt clips, holsters and similar accessories

should not contain metallic components in its assembly. The use of accessories that do not

satisfy these requirements may not comply with FCC RF exposure requirements, and should be

avoided.