User's Manual

1. PTT Key
2. Sk1(SideKey 1)
3. SK2(Side Key 2)
4. SK3(Side Key 3)
5. Speaker
6. Microphone
7. Body Case
8. Radio On-Off/Volume Control Knob
9. LED Indicator
10. Channel Selector
11. Top key
12. Antenna
14. Accessory Jack
15. Accessory Screw
16. Battery Latch
17. Strap Hole
18. Belt Clip
19. Battery
13. Name Plate
Installing Belt Clip
Match the grooves of belt clip with those on the rear of
radio and press the belt clip downwards until it is locked.
Installing/Removing the Belt Clip
Removing Belt Clip
Use your nail or a tool to lift the metal spring piece in
the belt clip from topside and pull the belt clip upward
from the battery pack.
Note:
1. To use belt clip, please install the belt clip onto the
battery before the installing of battery pack.
2. Remove the battery from the radio before the
removing of belt clip.
Installing Hand Strap
Thread the strap into the hole at the back of the
radio and fasten it.
Attaching the Audio Accessory
Programming Cable
1.Remove the screw on the accessory jack cover,
open the accessory jack cover as figure show below.
2.Align the plug with the accessory jack.
3.Tighten the screw on the plug.
Removing the Accessory
To remove accessories, loosen the
screw as figure shown below.
(Figure 1) (Figure 2)
09 10
11 12
Radio Overview
Attaching and Removing Attaching and Removing
Radio Overview
Radio Overview