User's Manual

Removing the Antenna:
Rotate the antenna counter clockwise until you
can remove it.
Attaching/Removing the Antenna
Attaching the antenna:
1.Insert the antenna into the connector on the top
of radio by holding the antenna at its base.
2.Rotate the antenna clockwise to fasten it.
(Figure 1)
Match the two grooves of battery with corresponding
guides on the back of the radio. And make sure the full
contact and parallel between the battery and aluminum
chassis.
Then push the battery along the guide until the battery
latch locks.
Slide the battery away from the radio.
(Figure 2)
(Figure3)
Attaching the Battery
To remove the battery,first make sure the radio is
turned off, then push the battery latch in the opposite
direction of the mark “LOCK” to unlock it,and push
the battery latch downwards.
Removing the Battery
(Figure 5)
(Figure 6)
(Figure 4)
05 06
07 08
Get Acquainted
Attaching and Removing
Attaching and Removing
Get Acquainted
Applicable Battery Model:
lease charge with HQT approved battery; Using
other batteries may burst and cause personal damage.
Get Acquainted
Battery Information
Note:
1. Do not short-circuit the battery terminals or dispose
the battery in fire. Never attempt to disassemble
the battery pack.
2. Charge the battery in 0-45℃ temperature.
Otherwise the battery may not be fully charged.
3. Turn off the radio equipped with battery before
charge. Use the radio while charging may
interfere with charging.
4. Do not pull/plug the adapter and the battery during
charging to avoid interfere with the charging
procedure.
5. When the battery power consumes quickly even
if it is fully and correctly charged, that means the
battery life is over and please replace with new
battery.
6. Do not charge if the battery or radio is wet. Before
charge, you should dry it with cloth to avoid danger.
Warning:
Conductive metals suc h a s j e w e l ry, k e y o r
decorating lace may result in short ci r c u i t a n d
generate a large quantity of heat when coming to
contact with battery electrodes. Treat any battery
carefully especially when placing it into pocket, wallet
or other metal container.
Charge Operation
Please charge as follows:
1. Turn off the radio. Plug the DC connector of adapter
into the DC jack on the rear of the charger.
2. Plug the AC connector of adapter into an AC outlet.
3. After the charger is electrified, the LED glows red for
1 second and goes out. That means the charger is
ready for normal charging. If the LED flashes red, it
means the charger is not ready for battery charging.
4. Insert the battery or radio equipped with battery into
the charger. Make sure the battery is in good
connection with the charger electrode.
5. LED glows red during charging and flashed during
trickle charging because of very low battery power.
And after the battery power reached a certain mount
during trickle charge, the charger automatically turns
to normal charge mode.
6. The battery is fully charged when LED glows green.
The charger stops charging automatically.
Cautions in Charging
1. The battery is not charged in factory. Please charge
the battery before initial use or after long-time
storage.
2. Repeat charging 2 to 3 times will make the battery
reach its best capacity. Please replace or charge
the battery if battery power is low.
3. When the battery power consumes quickly even
if it is fully and correctly charged, that means the
battery life is over and please contact your dealer
and buy new HQT approved battery.
Antenna Information
Stubby antenna is suitable for short-distance
communication; thin and long antenna will
provide best communication effect. Also it is
comfortable to carry on the waist.
The communication range may be shortened in
rainy days or in forest. Please make preparations
for that .
Push the battery latch towards the mark “Lock” to
lock it.