User's Manual

10
Enable call transfer function.
Keypad isn’t unlocked.
Keypad locked.
Indicates battery level.
Indicates missed calls.
Enable chat function.
Enable multi-stopwatch function.
Receive new service message.
Turn on bluetooth handset.
Bluetooth handset pairs successfully.
2.2 Keypad Description:
1．Switch Key: On the top of mobilephone, press this key for a moment
to turn on or turn off the mobilephone.
2. End Key: It’s used to end calls or reject incoming calls. Press this key
to return to standby status under other conditions.
The description of every key and certain functions above depend on
specific models.
2.3 Battery
Battery under original status can be used afar charging by 50% power.
The full performance of a new battery is achieved only after the first
three complete charge and discharge cycles.
The disassembly and installation of battery
 Please follow steps below to disassemble the battery: ①Open the
back cover of the phone; ②Remove the battery from left;
 Please follow steps below to install the battery: ①Push down the
right end of the battery gently; ②Close the back cover of the phone.
2.4 Charge for Battery
 Connect the charger with power.
 Insert the end of the charger into the right side of the phone (Note: the
arrowhead shall be upward).
 Then, power indication icon on the screen flashes repeatedly. If the
phone is switched off during charging, there is power indication
image on the screen, which means that the battery is under charging.
If the phone is overused under low battery, then charging indication
icon will be displayed after the charging has been done for some time.
 If the power indication icon in the upper right corner is fully
displayed without flashing, it means the charging is complete. If the
phone is switched off during charging, there is image to indicate that
the charging is over. This process needs 3 –4 hours. It’s normal that