User manual

H7921-RHZ-i 3G Router User Manual
16
 Computer with Ethernet card and TCP/IP protocol
1. IE6.0 or higher
2. Support 1024x768 resolution display
3.2.2 Connection method
For your convenient use, we recommend you plug your SIM/UIM card into H7921-RHZ-i’s
card slot before your configuration. Then power on H7921-RHZ-i and begin your
configuration. Upon the actual conditions, connect and configure Galaxy H7921-RHZ-i 3G
Router by the following two methods:
Note:
You can configure H7921-RHZ-iwithout any card, but you may not connect to the internet until you
insert a SIM/UIM card.
Warning:
Never pull or plug your SIM/UIM card when H7921-RHZ-i is power on. Your card may be damaged.
Warning:
The metal casing of H7921-RHZ-i 3G Router has to be well connected to the ground so as to ensure
the router a safe, stable and reliable operation.
3.2.2.1 Ethernet direct connection method
Using Ethernet cable with RJ-45 connector, directly connect the computer to one of LAN
ports on Galaxy H7921-RHZ-i 3G Router as shown in the figure below:
Fig. 3.2.2.1: Wiring Method 1
Note: Galaxy H7921-RHZ-i 3G Router’s LAN port is designed with self-adaptive cross
connect technology, so the straight-through cable or cross cable can be both applied to
connect devices for communication.