SHENZHEN HONGDIAN TECHNOLOGIES CO., LTD.
MOBILE DATA COMMUNICATIONS Galaxy Mobile Router (H7920) Notice: Copyright The contents of the manual are protected by Chinese law, any organization and/or person can not copy this manual or part of contents without Shenzhen Hongdian Technologies Co., Ltd. authorization in written. Trademark 宏电 、 、Hongdian, GPRS/EDGE DTU, CDMA DTU, MDTU, Wireless DDN, Hongdian, Hongdian Technologies and Shenzhen Hongdian are the logos and trademarks of Shenzhen Hongdian Technologies Co., Ltd.
Abbreviations HLR Home Location Register HSCSD High Speed Circuit Switch Data IGMP Internet Group Management Protocol IGRP Internet Gateway Routing Protocol APN Access Point Name IN Intelligent Network APP Application IP Internet Protocol ATM Asynchronous Transfer Mode IPv4 IP version 4 ATM Auto Table Machine IPv6 IP version 6 AuC Authentication Centre IPSEC IP Secure Protocol BG Border Gateway ISDN Integrated Services Digital Network BGP Border Gateway Protocol ISP Inter
RSC Register Service Center RTOS Real Time Operating System RTP Real-time Transport Protocol RTU Remote Terminal Unit RSVP Resource reSerVation Protocol SCADA Supervisory Control and Data Acquisition SGSN Serving GPRS Support Node SIM Subscriber Identify Module SMS Short Message Service SMSC Short Message Service Center SNMP Simple Network Management Protocol STK SIM Tool Kits TCP Transmission Control Protocol TDMA Time Division Multiple Access TMN Telecommunication Managed Netw
Contents CHAPTER 3 ROUTER CONFIGURATION ............................................................14 INTRODUCTION ...................................................................................1 3.1 CONNECTION............................................................................................................14 1.1 GENERAL .....................................................................................................................1 3.2 CONFIGURATIONS ...............................
Galaxy H7920 Mobile Router User Manual Chapter 1 Chapter 1: Introduction Chapter 1: Introduction GPRS network theoretically can provide a maximum bandwidth 171.2Kbps, actually; it works at 40~100Kbps bandwidth (it depends on service provider’s operation policy). As we know, GPRS is packet based network which provides TCP/IP communication channel. Introduction This chapter introduces the Galaxy H7920 Mobile Router general descriptions, features and philosophy. 1. 2. 3. 4. 5.
Galaxy H7920 Mobile Router User Manual Chapter 1: Introduction Galaxy H7920 Mobile Router User Manual Power Enhanced Features Support multiple protocol conversion Support data center and network management Online detection and redial Online/Offline control Online/Offline controlled by user’s equipment Online/Offline triggered by user’s data Timing online/offline STK/UTK card special function configuration Support Ethernet and RS-232/485 interface Synchronize with CDMA network Self-diagnostic Optimize EM
Galaxy H7920 Mobile Router User Manual Chapter 1: Introduction Galaxy H7920 Mobile Router User Manual Chapter 1: Introduction GPRS GPRSoror CDMA CDMA1X 1X Network Network Internet Internet GPRS GPRSoror CDMA CDMA1X 1X Network Network Internet Internet RS-232 RS-232 Serial port/Mobile network transmission It is the solution to convert and transmit non IP device data over TCP/IP based mobile data network (GPRS/EDGE/CDMA 1x). Connect the non IP device to the Galaxy serial port.
Galaxy H7920 Mobile Router User Manual Chapter 1: Introduction POS Galaxy H7920 Mobile Router User Manual Chapter 2 Router Chapter 2: Installation Installation This chapter describes the Galaxy router installation procedures, power on and initial setup. GPRS/EDGE GPRS/EDGE CDMA CDMA 1. 2. 3. 4. 5. 6. Galaxy H7920 PSTN PSTN General Open Box Installation and Cable Connection Grounding Power Supply Check the Mobile Network V.90 Modem 2.
Galaxy H7920 Mobile Router User Manual Chapter 2: Installation A valid GPRS/EDGE SIM card or CDMA 1X UIM card (Depends router type) Galaxy router should be placed on desktop, wall or any other fixed place. There is no special requirement for wiring and heating dispersion.
Galaxy H7920 Mobile Router User Manual Chapter 2: Installation Galaxy H7920 Mobile Router User Manual Chapter 2: Installation Connectors’ description: COM: Serial port (RS-232/485), serial data port or console port. RJ45: 10/100BaseT auto sense Ethernet interface. DC: DC power supply interface (+5VDC, +7.5V~+24VDC optional, check the label before power on.) RESET: Reset button, press and hold for 5 seconds to reset the Galaxy router back to its default factory configurations.
Galaxy H7920 Mobile Router User Manual Chapter 2: Installation Attention! Normally, the power supply is +5VDC, +7.5V~+24VDC is optional. You should check the Galaxy router label before power on. Galaxy router should be powered by the AC adapter supplied by Hongdian. Hongdian will not guarantee Galaxy router performance if it is powered by any other unqualified AC adapter. Connect antenna properly before power on. 2.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Your PC Setup Correct Network Settings You may be required to configure your PC IP address and associated parameters after connecting the PC and router. You can set PC IP address “Obtain an IP automatically” or set it manually. Refer to below descriptions for details. Below is Galaxy router factory default setting; you can modify it accordingly. IP Address: 192.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Here, you can select “Obtain an IP automatically” or “Use the following IP address”. If Galaxy router is connected to your PC directly, it is possible to select “Obtain an IP automatically”. Galaxy router built-in DHCP server will assign an IP address to the connected PC. Sometimes, the PC may be required to restart. At LAN connection situation, the PC may be already assigned a LAN address (Show as above picture).
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Main Menu Router Status: Display major parameters configuration and operation information. Online Help: Provide online help. System Tools: Provide a set of tools for the router management, such as modifying password, remote management, profile backup, hardware & software information, log and restart tool.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual RF Signal: It displays Galaxy router received GPRS/EDGE or CDMA RF signal strength in dBm unit. If the received RF signal is lower than -80dBm, it displays the RF strength with "BAD" word. Router ID: It is the router's unique identity name for industries and utilities application. Click "Start">"Special Setting">"DTU Setting" to modify it.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Router Administration Click "Start"->"System Tools"->"Router Administration" menu to start this setup page. This is the detail operation instructions; all configuration and setting procedures have been described in the Online Help file.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration With the built-in with real time clock function, GALAXY router will be automatically synchronized with clock sources when it is powered on. For CDMA version, Galaxy router will be locked at CDAM network clock source. For GPRS/EDGE version, Galaxy router will be synchronized to an Internet clock source (NTP) when it has been connected to GPRS/EDGE network.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration System Log Click "Start"->"System Tools"->"System Log" menu to start this page. There are four sub-menus at "Network Setting". Network Basic Setting DHCP Configuration SNMP Configuration Dynamic DNS Network Basic Setting Click "Start"->"Network Setting"->"Network Basic Setting" menu to start this setup page.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Press "Save" button to store the modification. Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration W-ICMP Detecting Reconnecting the host (or PC) after its IP address has been modified successfully. The WAN side IP link status detecting can be enabled or disabled. Also the detecting interval (second), retries and destination (host) can be specified.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Use Peer DNS Normally, it is not required to change the setting for most of networks and applications. If it is necessary, please consult with the local mobile operator and try different settings. It is the option to utilize mobile network gateway (GGSN or PDSN) DNS setting. DHCP Configuration DHCP means Dynamic Host Configuration Protocol.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration SNMP: Enable or Disable, tick it to enable the SNMP function. It supports SNMP V1 and V2C (V3 ready) automatically. Set Community: Set the community name, such as "public". IP: Set the SNMP management IP address. Usually, it is the router LAN interface IP address. System Name: Set the router name that will display on the NMS. System Contact: Set the router contact name. System Location: Set the router location.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration NAT/NAPT Configuration Security Configuration Routing Table Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration port has been mapped to a host at the LAN, the data at this port will be transferred to this host, and not be transferred to the defined DMZ host. Galaxy router can map up to 10 ports (hosts). NAT/NAPT Configuration Common used ports list: NAT is the abbreviation of Network Address Translation.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Security Configuration With the security configuration function, you can control data envelops security in/out your network. All outbound envelops are secured by this setting. Only envelops to NAT or DMZ hosts toward inbound direction are secured. Click "Start"->"Route Configuration"->"Security Configuration" menu to start this setup page. Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration For example: 4.3.2.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration For Example: Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration 3.2.6 Special Setting Galaxy router is not only integrated with router functionality, but also can be configured for many other applications. The Special Setting function is designed for industries and utilities. Several parameters can be configured accordingly.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration For many applications, it requires to keep the links always online. The heartbeat setting should be set to keep the links alive. However, the heartbeat is the data traffic packets and it may be charged (depends service provider). You have to set a right heartbeat interval in accordance with application.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Operation Mode: Enable or disable. Timing: Specified the online time and offline time, press ADD button to add the timing plan to the time schedule. Schedule: Display the specified time schedule. Select a timing plan and press DEL button to delete it.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Route Detecting: Detecting the destination host IP address, if there is no response at the set time interval and times, the router will switch over to the selected backup route. Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration Click the "COM Port Setting" button to this setup page.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration RUN LED, blinking in 1 second interval; it indicates Galaxy router works at default route (main route). RUN LED, blinking in 2 second interval; it indicates Galaxy router works at backup route. 3.2.7 Hongdian Products Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration TFTP update H7920 is built-in with a tftp client. Operator can update the firmware via a TFTP sever.
Galaxy H7920 Mobile Router User Manual Chapter 4 Chapter 4: Operation Instruction Operation Instruction Galaxy router is an embedded hardware and software platform. Normally, it is working without any manual operation. It provides a reliable and flexible data channel for industrial applications. Panel Indication Operation Trouble Shooting Galaxy router should be installed at place with good radio signal receiving. For the cabinet and basement environment, we recommend to extend the antenna. 4.
Galaxy H7920 Mobile Router User Manual Chapter 4: Operation Instruction (Note: Galaxy router’s LINK and PC’s Link should lights-up if it is connection). Check your TCP/IP setting. (Note: If the Galaxy router LAN IP is 192.168.8.1, your PC local connection IP address should be 192.168.8.xxx). For more checking, type “ipconfig” command at DOS prompt.
Galaxy H7920 Mobile Router User Manual Appendix 1: Hypertext Terminal Setting Galaxy H7920 Mobile Router User Manual Appendix 1: Hypertext Terminal Setting The COM port parameters should be specified. Select COM number (i.e. COM2), Bites per second, Data bits, Parity, Stop bits and Flow control. 3. Host System Encoding Method Click “Input Translation” button, set host system encoding method. Notice: “Flow control” should be set to “None”. 2. Properties Start the created H7000 HyperTerminal connection.
Galaxy H7920 Mobile Router User Manual Appendix 1: Hypertext Terminal Setting 4. ASCII Setup Galaxy H7920 Mobile Router User Manual Appendix 2: Firmware Update Tool Appendix 2: Firmware Update Tool Click “ASCII Setup” button, set ASCII parameters. This appendix describes Galaxy router firmware update tool user instructions. Galaxy H7920 Firmware Update Tool Set up the PC IP address subnet same as the router that will be updated. Copy the Router Update Tool to the PC and run it (Fig. 1): Fig.
Galaxy H7920 Mobile Router User Manual Appendix 2: Firmware Update Tool Galaxy H7920 Mobile Router User Manual Appendix 2: Firmware Update Tool Warning 1. Do not disconnect or power off the router during firmware updating. 2. Mobile network may be failed sometimes; it is a high risk to update firmware remotely. Fig. 3 Fig. 4 Press “Update” button to update the router firmware (Fig. 5) Fig. 5 Fig. 6 Waiting about 20 seconds, “Update success” info will appear.
