User manual

H8951 3G SOHO Router User Manual Chapter3: Router Configuration

Normally, it is not required to change the setting for most of networks and

applications. If it is necessary, you need to be cautious in setting PPP Advanced based

on the network environment. For detailed configuration, consult the local mobile

operator and carry out multiple trials to achieve the best suitability.

【CHAP, PAP, MS-CHAP, MS-CHAPv2】are negotiation protocol types while PPP

dialing.

【Compression Control Protocol negotiation】: Set whether disable Compression Control

Protocol negotiation. 0: disable; 1: enable.

【Address/Control compression】: Set whether disable Address /Control compression.

【Protocol field compression negotiation】: Set whether disable protocol field

compression negotiation

【VJ style TCP/IP header compress】: Set whether disable Van Jacobson style TCP/IP

header compress.

【Connection-ID compression】: Set whether disable the connection-ID compression

option in VJ.

【Debug】: Set whether enable the debug log function.

【Use Peer's DNS】: Set whether disable Use Peer's DNS.

【LCP Echo Interval】: Set LCP’s maximum interval time, in second.

【LCP Echo Failure】: Set LCP’s maximum request times.

【MTU】: Set the number of bytes of the maximum transfer unit.

【MRU】: Set the number of bytes of the maximum receive unit.

【local IP】: Set the local IP address.

【Remote IP】: Set the remote terminal’s IP address.

【Other Options】: Users can define their own options here.

3.3.2.2 WAN configuration

In the “Internet” main tab, click the “WAN” sub-tab to go to WAN port setting page.

Select the internet connection method from the “Mode Type” drop-down menu:

“Disable”, “Static IP”, “Automatic Configuration-DHCP” and “PPPoE”. The default

setting is “Disable”, namely the WAN port’s route function is disabled. Below, we will

describe how to configure the WAN port in different modes:

1. Static IP configuration

When private network access is realized by static IP address, you need to select the

“Static IP” option to go to the following configuration interface: