User manual

H8951 3G SOHO Router User Manual Chapter3: Router Configuration
Chapter 3 Router Configuration
3.1 Overview
Galaxy H8951 3G SOHO Router features built-in WEB interface configuration,
management and debugging tools. Before using Galaxy H8951 3G SOHO Router, users
should configure relate parameters; during using, you can freely change related
parameters and perform software upgrade and simple test etc.
When you enter Galaxy H8951 3G SOHO Router built-in WEB configuration interface,
you can set and manage its parameters as described below.
3.2 Connection settings
3.2.1 Environment requirements
When you want to use Galaxy H8951 3G SOHO Router, a computer and a UIM/SIM card
should be prepared according to the following requirements:
 Computer with Ethernet card and TCP/IP protocol
1. IE6.0 or higher
2. Support 1024x768 resolution display
3.2.2 Connection method
For your convenient use, we recommend you plug your SIM/UIM card into H8951’s card slot
before your configuration. Then power on H8951 and begin your configuration. Upon the
actual conditions, connect and configure Galaxy H8951 3G SOHO Router by the following
two methods:
Note:
You can configure H8951without any card, but you may not connect to the internet until you insert
a SIM/UIM card.
Warning:
Never pull or plug your SIM/UIM card when H8951 is power on. Your card may be damaged.
3.2.2.1 Ethernet direct connection method
Using Ethernet cable with RJ-45 connector, directly connect the computer to one of LAN
ports on Galaxy H8951 3G SOHO Router as shown in the figure below: