User manual

Galaxy H7921 Mobile Router User Manual Chapter 3: Router Configuration
M80-792101-01
27
There are five sub-menus at "Network Setting".
 Network Basic Setting
 PPP Setting
 DHCP Configuration
 SNMP Configuration
 Dynamic DNS
Network Basic Setting
Click "Start"->"Network Setting"->"Network Basic Setting" menu to start this
setup page.
LAN Setting
There are three LAN IP addresses and netmasks that can be utilized. However,
the host (or PC) that connect with Galaxy router should be configured at the
same netmask as one of the three LAN addresses setting.
 First LAN IP address (default): 192.168.8.1
 LAN Netmask: 255.255.255.0
 Default Route: Configure the default data transmission path.
Galaxy H7921 Mobile Router User Manual Chapter 3: Router Configuration
M80-792101-01
28
 Default DNS: Configure the DNS server IP address, there are three DNS
server can be defined.
It can be modified in accordance with application requirement.
Press "Save" button to store the modification.
Reconnecting the host (or PC) after its IP address has been modified
successfully.
PPP Setting
Those parameters should be configured in accordance with the information
provided by local service provider.
Click "Start"->"Network Setting"->"Network Basic Setting" menu to start this
setup page.
 Dial
It controls the RF module dialup mode; the default setting is "Auto".
When it is set to "Auto" mode, Galaxy router will automatically dial mobile
network and will re-dial if the mobile link fails. After 3 failed dialing, Galaxy router
will automatically restart RF module. When it is set to "Manual" mode, the timing
work mode for special setting may not be active.
Tick the “Default Route” option to route data via GPRS/EDGE or CDMA path.
 Service Code
Configure it with a correct service code provided by the service provider, the
default setting: