User manual

Galaxy H7921 Mobile Router User Manual Chapter 3: Router Configuration
M80-792101-01
19
Main Menu
Router Status
: Display major parameters
configuration and operation information.
Online Help
: Provide online help.
System Tools
: Provide a set of tools for
the router management, such as modifying
password, remote management, profile
backup, hardware & software information,
log and restart tool.
Network Setting
: Provide LAN interface,
DHCP, mobile network parameters setting
and dynamic DNS configuration.
Route Configuration
: Set up NAT, DMZ,
VPN and the route paths.
Hongdian Products
: Browse Hongdian
Products catalogue.
Logoff
: Exit router management pages.
Notice:
Galaxy router should be configured properly; the “Network Setting” is the
basically and necessarily settings. We recommend customer should configure
this parameter first. Meanwhile, we suggest customer reads paragraph 3.2.4
before setting.
As mentioned before, the router configuration works should be performed via a
PC that is configured. The relative descriptions refer to paragraph 3.1.
Galaxy router factory default setting:
LAN IP Address: 192.168.8.1
Subnet Mask: 255.255.255.0
Login Name: admin
Password: hongdian
You can modify above settings accordingly; and you may need to modify the PC
IP address settings if the router settings have been changed.
Press and hold the “RESET” button for 5 seconds to restore the default setting.
Galaxy router is designed for industrial application and it works at
dial mode. However, at the beginning step, the router may not be
inserted a valid SIM/R-UIM card or configured incorrectly. The router
will try to dial and connect mobile network until establish the
communication channel. If it fails 3 tries, the router will restart
automatically. It will interrupt your configuration work. Therefore,
we recommend set dial mode to “Manual” by clicking
“Start”->“Network Setting”->“PPP Setting”.

Galaxy H7921 Mobile Router User Manual Chapter 3: Router Configuration
M80-792101-01
20
Console Mode
The Galaxy router RS-232 interface can configured for a data communication
port or a Console port. The Console port is only used for factory testing and
trouble shooting.
3.2.1 Router Status
Click "Start"->"Router Status" menu, the Galaxy router general operation
information will be displayed.
The page displays the router interface IP and MAC address information:
 eth0~eth2: the Ethernet interface IP and MAC address
 IPSec0~IPSecN: the IPSec VPN channel information
By clicking the “Packet Information” button to view the interface traffic.