User manual

Galaxy H7921 Mobile Router User Manual Chapter 2: Installation
M80-792101-01
11
CD 1
RX 2
TX 3
DTR 4
GND 5
DSR 6
RTS 7
CTS 8
RING 9
1 CD
2 RX
3 TX
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RING
RS-232 DB9 (Male)RS-232 DB9 (Male)
RS-232 Modem
CD 1
RX 2
TX 3
DTR 4
GND 5
DSR 6
RTS 7
CTS 8
RING 9
1 CD
2 RX
3 TX
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RING
RS-232 DB9 (Male)RS-232 DB9 (Male)
RS-232 Modem
RJ45 – Ethernet
It is standard 10/100BaseT Ethernet interface (Auto sense).
DC – Power
DC power supply interface (+5VDC, +7.5V~+24VDC optional, check the label
before power on.)
The power adapter output current should be not less 2A; Power supply ripple
should be less 300mV.
ANT - Antenna
Standard 5O/SMA RF connector (Female)
For outdoor use, lightning should be considered. We propose to install an
arrester between antenna and the ANT interface.
2.4 Ground
To ensure a safe, stable and reliable Galaxy mobile router operation, DTU
cabinet should be grounded properly. Connect the Galaxy mobile router cabinet
to site ground wire.
2.5 Power Supply
Galaxy router is designed with advanced power management technologies; it
can operate standalone. The input DC power voltage is +5VDC (+7.5V~+24VDC
optional). You should check the Galaxy router label before power on.
The power adapter output current should be not less 2A; Power supply ripple
should be less 300mV.
Galaxy H7921 Mobile Router User Manual Chapter 2: Installation
M80-792101-01
12
Attention!
 Normally, the power supply is +5VDC, +7.5V~+24VDC is optional. You
should check the Galaxy router label before power on.
 Galaxy router should be powered by the AC adapter supplied by Hongdian.
Hongdian will not guarantee Galaxy router performance if it is powered by
any other unqualified AC adapter.
 Connect antenna properly before power on.
2.6 Check the Mobile Network
Connect all signal and power cables, and double check it, connect antenna,
insert a valid SIM or UIM (depends your router type and network) and switch on
power. Galaxy H7921 router “RUN” LED will light up. If “RUN” LED is flashing, it
means the Galaxy is working normally. If the “LINK” LED is flashing, it means
there are data stream input/out over router data port. If the “NET” LED lights up,
it means that the Galaxy router has found and logged on mobile network.
(More information refer to Chapter 4)
 All cables should be connected correctly before switch on.
 Antenna should be connected properly before switch on, otherwise it may
cause radio module problem.

