Specifications
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Regulation Information
1) List of applicable FCC rules:
FCC part 15.247
2) Summarize the specific operational use conditions
This Device and its antenna must not be co-located or operating in conjunction with any
other antenna or transmitter. The host product manufacturer should state this information
to the host instruction manual.
3)Limited module procedures:
This module is only use for battery-powered product and the shielding for RF module will be
provided in the host.
The
modular
transmitter
is
only
approved for use by the grantee in its
own
products
and
not
intended
for
sale
to
third
parties.
4)Trace
antenna
designs
No
applicable.
5)
RF
exposure
considerations
This
equipment
complies
with
FCC
RF
radiation
exposure
limits
set
forth
for
an
uncontrolled
environment without any restriction.
6) Antennas
Antenna types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
Antenna type: Integral Antenna
Antenna Gain: 0dBi
7)Label and compliance information
A host product shall use a physical label stating “Contains FCC ID:2AAUWHBT42A20N”