User's Manual
Zone 1
Power On/Off
Zone 2
Zone 3
POWER
POWER
+
+
Combination keys
1
ZONE
3
ZONE
Long press 5 seconds to clear binding records(Pairing)
Short press to send binding command(pairing). The controller/light
has to be binding mode while the command is sent.
Switch CCT mode
/DIM mode
Dimmer bar on DIM mode
CCT bar on CCT mode
3.5 3 Channels CCT Version
5.Environment and Electrical parameters
Input
Control range
Frequency
Operating temperature
AC100-240V
30m
2.4GHz
-20° C to 55°C
4.Application operation
Each of HTP601 device has QRcode. Download iLightsIn app from
APP STORE and connect the gateway WiFi. Then scan the QRcode on
HTP601 device to add in app. User can bind the HTP601 device with
lights in Binding settings of APP settings menu. After binding, the
HTP601 device can control the bound devices without gateway or app.
Long press to store current brightness
and color temperature of current zone.
Short press to call stored brightness
and color temperature of current zone.
4
Long press 5 seconds to turn on/off beep
POWER
2
ZONE
+
User can turn on night light function when
the whole touch panel is pressed.
Stop
3.6 Curtain Version
Up
Open
Long press 5 seconds to clear binding records(Pairing)
Short press to send binding command(pairing). The controller/light
has to be binding mode while the command is sent.
+
+
Combination keys
3.7 2 Channels Curtain Version
Open
Stop
Close
Stop
Close
Short press to send binding command(pairing). The controller/light
has to be binding mode while the command is sent.
+
Long press 5 seconds to clear binding records(Pairing)
+
Combination keys
Long press 5 seconds to turn on/off beep
+
POWER
1
ZONE
2
ZONE
3
ZONE
SAVE
CT/DIM
3
Down
Long press 5 seconds to turn on/off beep
+
This device complies with part 15 of the FCC Rules. Operation is subject
to the condition that this device does not cause harmful interference (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This
equipment should be installed and operated with minimum distance
between 20cm the radiator your body: Use only the supplied antenna.
FCC ID: 2AJ7E-HTP601-Z