User's Manual

To ensure the handwriting accuracy, use the pen provided together

ZLWKWKHLQWHUDFWLYHSDQHOUDWKHUD¿QJHUWRSHUIRUPFDOLEUDWLRQ

Calibration errors may cause failures in touch functions of the

interactive panel. In that case, please perform calibration again.

Tap ESC on the keyboard during the calibration process to cease

calibration.

The calibration interface varies between different software versions.

Please follow instructions provided on the actual interface.

Tips:

OPS Installation

Select Signal Channel

The OPS does not support hot-plugging. Please insert or pull out the OPS after the

interactive panel is disconnected from the power supply.

Insert the OPS into the slot and fasten it with two M4 screws respectively

on the top and bottom. Both the standard OPS and non-standard OPS

are supported.

Press Source WRGLVSOD\WKHOLVWRIVLJQDOVRXUFHV3UHVVŸźWRVHOHFWDQ

option and press OK to enter the sub-menu.

If no signal source is available, press 0(18. In the displayed list, set

signal Search to On. After 30 seconds, the interactive panel automatically

detects signal sources and switches to a signal source. The signal source

searching scope and priority sequence is: PC, HDMI1, HDMI2, HDMI3,

OPC-PC, Component, AV.

Standard OPS Non-standard OPS

NOTE: