User's Manual


To ensure the handwriting accuracy, use the pen provided with the interactive panel to implement
positioning. Do not use your fingers.

Positioning errors may cause touch function failure on the interactive panel. In this case, you need
to implement positioning again.

During the positioning process, you can press ESC on the keyboard to exit the positioning
operation.

The positioning interface varies among different software versions. Please follow the actual
instructions provided on the interface.
3.7 OPS Installation
The OPS does not support hot-plugging. Please insert the plug of the OPS after the
interactive panel is disconnected from the power.
Install the OPS by following the following steps:
Step 1 Insert the OPS into the special slot on the rear of the interactive panel.
Step 2 Tighten the screws.
Step 3 Confirm that the OPS is installed correctly.