Bluetooth Earphone BT105 User Manual
Specifications Bluetooth version: Bluetooth V4.2 Support: HFPV1.2, A2DPV1.3, AVRCPV1.4, HSP1.6, GAVDP1.2, IOP S/N: 96dB SNR stereo ADC and stereo DAC Sensitivity: -80dBm<0.1%BER Working distance: 10M Working frequency: 2.4０２ -2.480GHZ Transmission power: CLASS2，4dbm Audio S/N: ≥75dB Audio performance: SBC decoding Battery: 3.7V/80mAH built-in rechargeable Li-on battery Charging voltage: DC5V 45mA Charging time: about 1.
Function Introduction 1. Power on: long press for 2 seconds, voice prompts “Power on”. 2. Power off: long press off”. for 2 seconds, voice prompts “power Pairing 1. Initial Pairing: Bluetooth headset will enter pairing mode automatically, voice prompts“Pairing”. Turn on Bluetooth function on device and select BT105, no PIN code needed. Voice prompts “connected” when pairing successfully. 2.
Operating Guide Answer phone calls: Single press Hang up phone calls: Single press Re-dial last phone call: Double press Play/ Pause music: Single press Volume +/-: Single press / Previous/Next song: Long press / LED Indicator 1. Charging: Red light keeps on in charging mode, blue light on when fully charged. 2. Power on: Blue light on 3. Pairing mode: Green and blue lights flashing alternately. 4. Standby mode: Blue light keeps on. 5. Paired mode: Blue light keeps on. 6.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
