User's Manual

Specifications
Input
9V-2A，12V-2A
Output
15W for mobile phone area, 2.5W for
iwatch area, 5W for airpods area
Material
ABS
How to use:
Connect the USB cable and the indicator light will flash once
and then go off after the device starts. At this time, the self-test
of the device is completed. Press the Watch Pop-up button,
and put on the corresponding device for charging.
Special note:
It is necessary to install the rising silicone for mobile
phones when charging the iphone 12/13MINI (all mobile
phones of the remaining sizes are not required to be
installed. The mode of installation is as shown in the figure
below)