User's Manual

4
Basic Operation
Charging your device
Saving Battery Life
Please review the following several key points on extending the battery life of your tablet.
1. When device is not in use, press the power button once to go into sleep mode.
2. Shut down applications when not in use.
3. Turn off WLAN when not in use.
4. Disable application sync.
5. Set a shorter time for display backlight.
6. Reduce brightness on the display.
Press and hold the Power Button for 2-3 seconds to turn on the unit.
Sleep Mode
After the device is on, press the power button once and it will go into sleep mode. The
screen is now on standby and under low battery consumption. To wake up the device,
simply press the power button again.
Power Off
To power off the device, press and hold the power button for 2-3 seconds until the
screen displays “Power Off”, then select “OK” to power off the unit completely.
Powering On
Reset / Force Shutdown
If the device is locking up, use a small pin to press
Reset as it will force shut down and restart the device. You can also perform a hard reset by
press and holding the Power and ESC buttons at the same time for 3-5 seconds. Then
press ESC buton to select “wipe data/ factory reset.” Now press the Power button to confirm
your selection. Then press ESC button again to select “Yes--delete all user data,” and press
the power button to confirm your selection. Finally the screen will display “reboot system
now” press the power button to confirm. Your device will reboot and start up normally.
To ensure the longevity of your battery, please charge your tablet for 10 hours upon initial
charge. Afterwards,charge the device accordingly as needed. Connect the DC adapter that is
supplied with your device and plug it into an AC outlet that supports 100-240V ~50/60 Hz
If battery is 0% please plug in charging cord for about 3-4 hours for a full charge.