User's Manual

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Specic Absorption Rate (SAR) information

SAR tests are conducted using standard operating positions accepted by the

FCC with the phone transmitting at its highest certied power level in all tested

frequency bands, although the SAR is determined at the highest certied power

level, the actual SAR level of the phone while operating can be well below the

maximum value, in general, the closer you are to a wireless base station antenna,

the lower the power output. Before a new model phone is a available for sale to

the public, it must be tested and certied to the FCC that it does not exceed the

exposure limit established by the FCC, Tests for each phone are performed in

positions and locations (e.g. at the ear )as required by the

FCC. This handset has also been tested and meets the

FCC RF exposure guidelines.Use of otheraccessories may Non-compliance with

the above restrictions may result in violation of RF exposure guidelines.

IMPORTANT NOTE

FCC Radiation Exposure Statement: This equipment complies with FCC

radiation exposure limits set forth for an uncontrolled environment .This equipment

should be installed and operated with minimum distance 20cm between the base&

your body. This transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter.

Connecting to a switchboard

This product is intended for use within US for connection to the public telephone

network and compatible switchboards, which support tone dialling and timed break

recall. If in doubt please consult your service provider.