User's Manual

43
10. Using additional handsets
Up to 5 handsets can be registered to one base station. Additional handsets must
be registered to the base before you can use them.
The instructions described below apply specically to the Colombo handset. If
you wish to register another manufacturer’s handset, the instructions may vary.
In this case, please refer to the instruction manual of the additional handset.
The System PIN is required to register or de-register handsets. The default
PIN is 0000.
10.1 Registering an additional handset
NOTE
Handset batteries must be fully charged before you start to register. Hold your
handset close to the base during the registration process. Handsets that were
supplied with your Colombo base are already preregistered.
On the base:
1. Press and hold
for at least 4 seconds and the base will be ready
accept additional handsets. The base will remain in registration mode for 90
seconds.
On the handset:
1. Press
Menu
, scroll to
Registration
and press
Select
.
2.
Register Handset
is highlighted. Press
Select
.
3. Bases are displayed. If necessary, scroll
or to a new base you wish to
register the Colombo handset to and press
Select
.
4. If you are replacing a base that is already indicating
In Use,
when you press
Select
the display shows
Replace Base X?
Press
Yes.
5. Enter the system PIN and press
OK
.
6. The display shows
Searching Base X
.
7. When registration is successful the display shows
Handset Registered
and you hear
a conrmation beep.
NOTE
If registration is not successful the rst time, please repeat the process again in
case the base registration period ran out of time. If the base is not found after a
few seconds, the handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, registration will fail. You
must de-register a handset before you can register a new one.
Using additional handsets