User's Manual

• In idle, all the handsets which registered to the same base can enter the “SETUP” menu in
4.5.
This me me
desired volume (VOLUME OFF or VOLUME 1 to 5) and validate
4.5.2
menu enables you to select base ring melody
dset’s association with a base to allow another handset to be associated
NDSET" and validate
ode and validate
t the handset to be cancell validate
CODE
code is used in subscriptio peration or to modify some critical parameters in the base.
he PIN code:
ct "PIN CODE" and validate
r the old 4 figure confidentia nd validate
ter the new 4 figure confident e
r the new confidential code alidate
user may cancel out of the PIN code entry, using a long press of the <KEY_CLEAR>
ial mode selection (This mod ot appear when set the Pulse dialling disable by
EPROM)
dialling are available:
MF tone dialling
Pulse dialling
dialling mode:
IALMODE” and validate
NE” or “PULSE” of dia
selected by EEPRO
ote: the Dial mode selection menu can be hidden to lock the base into pulse or DTMF dialling by the
on selection
• Choose RECALL 2 to select long flash time
ECALL 1 & 2 timing : selected by EEPROM data
on in if RECALL 1 & RECALL 2 is same timing. The recall menu will be
se.
the same time, and the last setting will be validated.
1 BASE VOL
nu enables you to adjust base ring volu
• Select "BASE VOLUME" and validate
• Select the
BASE MEL
This
• Select "BASE MELODY" and validate
• Select the melody of your choice (1 to 5) and validate
4.5.3 DEL HS
You can cancel a han
• Select "DEL HA
nter the PIN c• E
• Selec ed and
4.5.4 PIN
The base PIN n o
tTo change
• Sele
te• En l code a
• En ial code and validat
nd time and v• Ente
he
a seco
• T
4.5.5 D e will n
E
Two types of
1. DT
2.
To change the
• Select “D
• Select “TO l mode and validate
data FTXX_DIAL_MODI : M
N
CONFIG_ENA_MENU_DIALMODE flag (see various factory settings).
.5.6 Recall durati4
• Select "RECALL"
• Choose RECALL 1 to select short flash time
R
Note: not recall select functi
hidden from the user in this ca
52 of 83