User's Manual

• Select ”RECEIVE 1” or “RECEIVE 2” and validate
• Modify & validate the service centre number
• Press KEY_OK to confirm
On entering either Receive 1 or Receive 2 Centre numbers, the user should have the ability to clear
the previously entered number i.e. a zero length string will be permitted.
A new EEPROM parameter will be defined to hide the SMS service centre menus. A single parameter
will m th of the RCV CENTRE numbers as well as both of the SEND be aintained which effects bo
CEN R T E numbers.
In ad ers are identical when shipped from the factory, then RECEIVE dition, if both RCV CENTRE numb
2 option under the RCV CENTRE menu will not be available to the user. Only th
ill be available for the user to change.
e RECEIVE 1 option
w
this case the SMS SETTINGS menu option will be as shown below.
In
SMS SETTINGS MSG ALERT ON
OFF
SEND SERVICE SEND 1
SEND 2
RCV CENTRE RECEIVE 1 NUMBER ?
SEND CENTRE SEND 1 NUMBER ?
SEND 2 NUMBER ?
TERMINAL NO NUMBER ?
efault value will be that the display of the service centre menus will be ENABLED.
D
Note that the menus will not be disabled if the user changes the RECIEVE numbers to be identical at a
later date. In this case the menus will remain.
4.4. 5.6 SEND CENTRE
ages can be entered. A maximum of two The m nu ber of the service centre from which to receive mess
service centres will be supported for outgoing messages.
• Select “SEND CENTRE”
• Select ”SEND 1” or “SEND 2” and validate.
• Modify & validate the service centre number
• Press KEY_OK to confirm
A new EEPROM parameter will be defined to hide the SMS service centre menus. A single parameter
will be maintained which effects both of the RCV CENTRE numbers as well as both of the SEND
CENTRE numbers.
In this case the SMS SETTINGS menu option will be as shown below.
SMS SETTINGS MSG ALERT ON
OFF
SEND SERVICE SEND 1
SEND 2
TERMINAL NO NUMBER ?
50 of 83