User's Manual
Table Of Contents
- Feature List
- Features of SunCorp GAP DECT
- Main User interface
- Call User interface
- MENU Settings
- MESSAGE PLAY
- PHONEBOOK
- TAM SETTING
- SMS
- SETUP
- HANDSET
- REGISTER
- Answer machine features
- Base description
- Base unit operation
- Call answering and message recording
- Memory full
- Message playback
- Remote interrogation.
- Technical requirement
- Default setting data
- Setting for countries variance and type of product
- BPR detection (Branch Phone Detection)
- CPC (ECS) detection (End of call signal)
- Silence detection
- Tone detection
- DTMF detection
- AGC for recording
- Audio out put level setting
- Supervisory tone
- Tail cut
- Ring signal detection
- LED flashing
- Data storage
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
3.13 Range indication
When the handset is out of r
access the functions, the us
ange of the Base, certain functions will not be available. On trying to
er will be presented with an error beep. Where a function is not available,
is described in the individual menu section.
Not option has been
ena d erence source not found..
s are applied:
s been out of range since EEP_RANGE_OUT_DELAY s
•
a TONE_WARNING has been played, a TONE_IN_RANGE is played when the handset goes into
GE only if it goes into range after more than 10
ing a call
all is released (on both handset and base).
tion
.14.1 During idle
llow the handset internal ring level. However, if the setting is “OFF” the alarm
o to talk mode.
do not press any key for more than one minute, the alarm shall stop automatically.
.14.2 During Talk
The sound level shall be same as Battery Low warning tone. During generating the alarm sound, press
any key to stop the alarm without any operation.
it
e for all descriptions below, the TONE_WARNING will only be sounded is the
ble , as described in section Error! Ref
3.13.1 Out of range tone
If the following condition
• The handset ha
If range warning tone option is ON
then a TONE_WARNING will be played.
EEP_RANGE_OUT_DELAY : selected by EEPROM data
3.13.2 In range tone
If
range the next time.
Note: at start-up, the handset plays the TONE_IN_RAN
s.
3.13.3 Range limit tone dur
During a call, in range limit conditions, the handset will play a TONE_WARNING in the Buzzer
The tone is repeated until range conditions are good
If the handset goes out of range, the c
3.14 Alarm activa
When the unit is set to alarm ON and the clock reach to the alarm setting time, the handset shall
generate the alarm sound
and display “ALARM ON” on LCD. Once the clock is reach to alarm setting
time, the alarm setting shall be OFF.
3
The sound level shall fo
sound level shall be “LEVEL 1”. During generating the alarm sound, press any key to stop the alarm
without any operation even the handset is “Key Lock” mode. For example, press “KEY_HOOK” to
stop the alarm, however, the handset should not g
If
3
33 of 83