User manual Product Name: 4G body worn camera Model: F2, F1, F1P, F1B, F1S, F2B, F2P, F2S, F3P, F3B, F3S, F4P, F4B, F4S, F5P, F5B, F5S, F6P, F6B, F6S Manufacture: Shenzhen Grand Time Technology Co.
Please read this instruction manual carefully before using the product, and keep it in a safe place. Before using: ●Repairs can only be carried out by professional technicians. Do not disassemble them. ●Do not modify or adjust the equipment for any reason. ●Do not place the 4G Smart Intercom Law Enforcement Recorder near the heating appliance. ●Do not place the 4G Smart Intercom Law Enforcement Recorder in extreme dust, moisture and water splashes.
Terminal battery use The performance of the terminal battery is affected by many factors, including your wireless bearer network configuration, signal strength, temperature when using the device, frequency of use, and features selected for use. For optimal battery performance, please observe the following rules: 1) Only allow the original battery to be charged in the device to avoid damage caused by incorrect charging.
Battery diagram： Button functions (power button, switch button, fingerprint button, self-timer button, video button, key file marker button, channel button, volume plus button, volume down button, SOS button, recording button, intercom button, camera button, flash button ) power button 1) Press and hold the power button for 3 seconds to turn it on. 2) Normal use, long press the power button for 3 seconds to shut down.
1) Press the channel switch button to switch the talkback group or the screen group button to select the corresponding group. volume button Press the volume up/down to adjust the terminal volume SOS button 1) Press this button in emergency mode to alarm the system and locate the alarm address. recording button 1) Press the record button or the screen main screen recording button to start recording; press the record button or the screen end recording button again to end the recording.
2) Return to the main menu interface on the touch screen: The front camera is activated by the preview button H0ME button on the touch screen: on the touch screen returns to the main interface 3) Press and hold the camera button or touch the TP icon to turn off the local camera function. Specific steps: 1) Press the camera button 2) Trigger voice announcement: “Now start ultra-clear camera” or “Now start high-definition camera”, “Now start standard-definition camera”.
5) Touch the TP 6) Touch the TP 7) Touch the TP icon to turn on the front sub camera for close focus shooting icon to enter the recording mode. icon to enter this interface , you can check the recording, video, and photo. 8) Touch the TP icon to enter a group where you can switch to it as needed. 9) Touch the TP icon to enter this interface for sleep time setting, video clarity setting, laser positioning light on and off, pre-recorded on and off.
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
