User's Manual

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission

limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S.

Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the

general population. The guidelines are based on standards that were developed by independent scientific organizations

through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin

designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile

phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is

1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested

frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone

while operating can be well below the maximum value. This is because the phone is designed to operate at multiple

power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base

station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested

and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe

exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the

FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 0.982W/Kg and

when worn on the body, as described in this user guide, is 1.151W/Kg(Body-worn measurements differ among phone

models, depending upon available accessories and FCC requirements). The maximum scaled SAR in hotspot mode is

1.151W/Kg, and the Max simultaneous SAR value is 1.56 W/Kg. While there may be differences between the SAR

levels of various phones and at various positions, they all meet the government requirement for safe exposure. The

FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in

compliance with the FCC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can

be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on

FCC ID: SW9-POWERII Additional information on Specific Absorption Rates (SAR) can be found on the Cellular

Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States and

Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue.

The standard incorporates a sub-stantial margin of safety to give additional protection for the public and to account for