User's Manual

(Fig7)
To locate the reverse light's 12/24VDC wire
it will be necessary to gain access to the rear
of the vehicle's tail light.
For help locating the vehicle's reverse light
circuit contact your vehicle's manufacturer
for vehicle specific wiring diagrams.
7.Once you have located the reverse light
circuit you will have to route the GT4062
Power Wire to that location. You must
securely fasten the Power Wire to prevent
it from being caught on any vehicle
component such as the trunk
hinge (Fig. 7). Never route the cable
outside the vehicle.
8.The reverse light sockets on most vehicles have two wires connected
to them. Usually the negative wire is black and the positive wire is a
colored wire. If you are uncertain about the wiring, you can use a 12/24
volt test light available at most auto parts stores to determine which is
the positive wire.
Camera's
Power Cable
Camera's
Power Cable
a.Remove the reverse light socket from its housing, then remove the blub
from the socket.
b.Engage the parking brake, turn the ignition key to the ON position, but
do not start the vehicle. Put the gear shift in the reverse position.
c.Attach the ground wire of the test light to the vehicle ground, then
touch one of the socket's contacts with the positive lead.
-6-
d. If the test light lights up, then the wire corresponding to that contact
is the positive wire. If it doesn't light up the opposite wire is the
positive wire.
9. After determining which wire is the positive and which is the negative,
turn off the ignition key, then remove the battery's negative cable.
Follow the manufacturer's instructions for the safe use of the test light.
(Fig6)