User's Manual

-5-

(Fig2)

Note:

* Some vehicle's may have a hole

available to pass the wire through, if not,

you need to drill a hole close to the location

of camera for the connector wire, and two

holes for the screws of camera installation.

* Before you drill those holes, you must

check out and make sure no other

components too close to your aiguille.

Before drilling, we strongly commend you

remove electrical parts or fuel system

behind the vehicle door and clear the

surroundings to avoid unexpected damages.

3. If the holes are all ready, pass the

of camera into the vehicle.(Fig3)

Install the camera by two screws supplied

and adjust the camera to an proper angle.

(Fig 4)

connector

wire

(Fig3)

(Fig 4)

(Fig 5)

4. Then connect the camera to the

transmission box GT406 .(Fig5)5

5. Fix the transmission box Gt406

on the surface by the sheet screws we

supplied. (Fig6)

Note:

* Generally we advise you put it on the

center of the license plate top.

6. Next you'll need to find the vehicle's reverse lights. Turn off the

vehicle's reverse lights. Turn the vehicle's ignition key to the accessory

position, engage the parking brake and put the car in reverse. Look at

the vehicle's tail lights to see where the reverse lights are located, they

are the white lights.