Operation Guide 2.4GHz Digital Solution Wireless Baby Monitor Kit Model No.: 82094 The graphics included are subject ta minor change with notice.
. Installation 4-1. Installation of Camera 4-1-1. Basic installation of Camera 1, Locate the camera to a specific position, 2. Connect the camera to the adapter and then slide the power switch to ON position. Note: (© This camera can also use dry battery as power supply. Please load 4 Aa batteries to the battery compartment at the back of camera with their polarities matched. @The AC adapter will work instead of batteries after it is plugged.
3. Rotate the rounded head of camera to a suitable angle for surveillance. « 4-1-2. Camera Learning setup If there is interference happened when using, the Learning Switch can avoid it. Push the Learning Switch on the back of camera from OFF to ON, and then press the Eliminate button on the receiver for 3 seconds. The clear picture will display on the screen. Ho need to switch channel for avoiding Interference 4-1-3. Camera alarm setup ‘The camera provides Sound Detection.
Sound Alarm Setup: Sound Alarm refers to the alarm staging sound. To set up sound alarm slide the alarm switch to VOX position . The system enter sound alarm mode stand-by to pick up sound for alarm to trigger . When sound is detected, the alarm begins to sound for 2 minutes uncial the Eliminate Alarm button is pressed to snooze for 35 seconds. After the 35 seconds is up, the sound alarm will automatically stand-by for the next alarm fo re-recur.
* Continue working for & hours 2. Adjust the volume control to & desired level. w Set the channel of receiver to be the same as camera by pressing the channel button continuously, and the pleasures will display on the serene. Note: The receivers original channels are defined corresponding to camera's before shipment. 5.
