Parts List

Table Of Contents

05 06

Preparation before using camera

1. Powering the Camera Unit

Insert one end of the included charging

cable into the USB jack on the back of the

camera.

Insert the other end into the included power

adapter. Then insert the adapter into the

socket.

After being powered on, the camera will automatically turn on. (The green light on

the base of the camera is on for a few seconds. At this point, the camera is turned

on successfully).

Preparation before using receiver

1.Power on the receiver (The receiver is provided with a lithium battery, if the

receiver has enough power, please go directly to the Step 2).

Insert one end of the charging cable into the USB charging

jack on the side of the receiver.

2. Receiver starting up

Press and hold the button on the receiver to start the receiver

At this point, a monitor screen will appear on the receiver.

Note: This device has been paired before leaving the factor y. If the receiver fails to

display on the monitor screen as described above, please re-try the device pairing

operation. For detailed steps, please refer to Page 9 “Camera Pairing”.

Insert the other end into the included power adapter. Then insert the adapter into

the socket.

2019/05/08 11:24:35

DC5V