User's Manual

14
This field shows the default device name. You can change the name
by either clicking Rename or clicking the name and editing the
name.
MAC Address
This field shows the MAC address of the Remote device.
Password
By default, this field is blank. You can click Enter Password and
enter the password.
To set the Password of the device (required when creating a private
network), click the device name in the lower panel to select the
device, and click Enter Password. A dialog box appears as shown in
Figure 7 to enter the password. The selected device name is shown
above the password field and you can verify the password by
clicking OK. The Password field accepts the Device password in
any case format, with or without dashed between them.
A confirmation box appears if the password is entered correctly. If a
device is not found, you are notified along with the suggestions to
resolve common problems. This process might take a few seconds.