User's Manual

79
country dependent and are firmware programmed at the factory to match the
intended destination. The firmware setting is not accessible by the end user.
4.3 Part 68 statements
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. On the bass unit of this equipment is a label that contains,
among other information, a product identifier in the format
US: SGEDL01BGAW95Z97. If requested, this number must be provided to the
telephone company.
The REN is used to determine the number of devices that may be connected to a
telephone line. Excessive RENs on a telephone line may result in the devices not
ringing in response to an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs, contact the local telephone
company. For products approved after July 23, 2001, the REN for this product is
part of the product identifier that has the format US: SGEDL01BGAW95Z97. The
digits represented by 01 are the REN without a decimal point (e.g., 03 is a REN of
0.3). For earlier products, the REN is separately shown on the label.
If your equipment causes harm to the telephone network, the telephone company
may discontinue your service temporarily. If possible, they will notify you in
advance. But if advance notice is not practical, you will be notified as soon as
possible. You will be informed of your right to file a complaint with the FCC. Your
telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the proper functioning of your equipment. If they do,
you will be notified in advance to give you an opportunity to maintain uninterrupted
telephone service.