User's Manual

Field Description

is disabled.

You need to enable IP QoS, and then you can set the

parameters in this page.

QoS Policy You can choose stream based, 802.1p based, or

DSCP based.

Schedule Mode

You can choose strict prior or WFQ (4:3:2:1).

Src IP The IP address of the source data packet.

Src Mask The subnet mask of the source IP address.

Src Port The port of the source data packet.

Dest IP The IP address of the destination data packet.

Dest Mask The subnet mask of the destination IP address.

Dest Port The port of the destination data packet.

Protocol The protocol responds to the IP QoS rules. You can

choose TCP, UDP, or ICMP.

Phy Port The LAN interface responds to the IP QoS rules,

including four LAN interfaces, one AP interface, and

four virtual AP interfaces.

Set priority The priority of the IP QoS rules. P0 is the highest

priority and P3 is the lowest.

IP Precedence You can choose from 0 to 7 define the priority in the

ToS of the IP data packet.

IP ToS The type of IP ToS for classifying the data package

You can choose Normal Service, Minimize Cost,

Maximize Reliability, Maximize Throughput, or

Minimize Delay.

802.1p You can choose from 0 to 7.

delete Select a row in the table and click it to delete the row.

delete all Select all the rows in the table and click it to delete the

rows.

3.6.5 SNMP

Choose Advance > SNMP. The page shown in the following figure appears.