User's Manual

45
WPS Authentication: The WPS service is enabled by default.
There are there methods used in the Wi-Fi Protected Setup. In order to use wps
authentication, you can select one method from the following there methods.
 Press the WPS button on the rear panel for more than 3 seconds.
 The router generates PIN, see the above figure. Click Regenerate PIN to
generate a new PIN, then click Start PCB, press WPS button on the
wireless client simultaneously. The wireless client automatically establishes
the connection with the router through the encryption mode, and you need
not to enter the key.
 The wireless client generates PIN. In the above figure, enter PIN of the
wireless client in the Client PIN Number field, then click Start PIN to
establish the connection.
Note:
The wireless client establishes the connection with the router through WPS
negotiation.The wireless client must support WPS.
3.5 Service
In the navigation bar, choose Service. The Service page that is displayed
contains DNS, Firewall, UPNP, IGMP Proxy, TR069, and ACL.
3.5.1 DNS
Choose Service > DNS. The DNS page that is displayed contains DNS and
DDNS.
3.5.1.1 DNS
Click DNS in the left pane. The page shown in the following figure appears.
Domain name system (DNS) is an Internet service that translates the domain
name into IP address. Because the domain name is alphabetic, it is easier to
remember. The Internet, however, is based on IP addresses. Every time you use
a domain name, a DNS service translates the name into the corresponding IP
address. For example, the domain name www.example.com might translate to
198.105.232.4. The DNS system has its own network. If one DNS server does