User's Manual

31
In this page, you can configure WAN interface of your router.
The following table describes the parameters of this page:
Field Description
Default Route Selection You can choose Auto or Specified.
VPI
The virtual path between two points in an
ATM network, ranging from 0 to 255.
VCI
The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to
31 are reserved for known protocols)
Encapsulation You can choose LLC and VC-Mux.
Channel Mode
You can choose 1483 Bridged, 1483 MER,
PPPoE, PPPoA, or 1483 Routed.
Enable NAPT
Select it to enable the NAPT function of the
router. If you do not select it and you want to
access the Internet normally, you must add a
route on the uplink equipment. Otherwise, the
access to the Internet fails. Normally, it is
required to enable NAPT.
Enabel IGMP You can enable or disable IGMP function.