User's Manual

6.
USB Mode Function
(1) The Controller plugged into the USB port of the SWITCH system charging stand through the
transmission line is automatically recognized as the SWITCH Controller, and the wired Controller
connection function of the Switch system needs to be turned on in wired mode.
(2) The Controller plugged into the USB port on the PC through the transmission line is automatically
recognized as X-INPUT Controller mode, and LED1+ LED4 indicator lights up. In the PC X-INPUT
mode, press and hold the “-” + “+” simultaneously for 3 seconds to switch to In D-INPUT Controller
mode; LED2+LED3 indicator lights up in D-INPUT mode.
(3) When pressing the L Button and connecting to the PS3 system with a USB cable, it will automatically
recognize the PS3 Controller mode.
(4) When the Controller is plugged into the USB port of an Android Device, it will automatically
recognize the Android Controller mode, and LED1+LED4 light up.
(5) LED Light Indication of all USB Modes: The SWITCH is automatically assigned the corresponding
channel indicator by the system; X-INPUT: LED1+LED4 indicators light up; D-INPUT: LED2+ LED3
indicators light up; PS3 mode: channel indicator lights are assigned by the system.
7. TURBO Speed Adjustment, 3 gears of repeat speed, 8Hz-12Hz-15Hz; the default is 12Hz
Press and hold the TURBO Button and then press the corresponding Button to set TURBO; A, B, X,
Y, L, ZL, R, ZR can be set; repeat the setting operation to cancel the setting; adjust the TURBO speed;
TURBO+UP: Increase the repeat speed by one gear; TURBO+DOWN: Decrease the repeat speed by
one gear.
8. SWITCH Motor Vibration Intensity Adjustment
Press and hold the L+ZL+R+ZR Buttons simultaneously for 3 seconds to adjust. There are 3 levels of
intensity, 25%-50%-100%; the default is 50%, and the corresponding gear light is always ON for 1 second
after setting with the motor vibrating for 1 second.
9.
Six-axis Calibration
In the Controller shutdown state, press and hold “B” + “-” + HOME simultaneously to turn on the
Controller, two sets of front and rear indicator lights flash, press the “+” key again to calibrate.
10. Reset Function
When the Controller function is abnormal or crashes, the state of the Controller can be reset by short
pressing the Pairing Button.
11.
Controller Reference Current
Current
Typical Value
Sleep Current
30UA
Pairing Current
<30MA
Working Current
<30MA
Motor Vibration Current
≈60-120MA
12.
Controller Electrical Specifications
Power Supply Mode
Built-in Lithium Battery
Usage Time
≈16 Hours
Battery Capacity
500MAH
Charging Time
≈2 Hours
Charging Mode
USB DC5V
Charging Current
<400MA
Motion Sensor
Six-axis Gyro Sensor
Vibration function
Supports Dual Motors