User's Manual

FCC Caution.
§ 15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
§ 15.21 Changes or modification warning.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
an be determined by turning the equipment off and on, the user is encouraged to try to
orrect the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
-EUT Operating temperature range: -20°C to 70°C .
Thedevice complies with RFspecifications when the device used at 5mmfrom your yourbody.
Riskof explosion if battery is replaced by an incorrect type. Dispose of used batteries according to
the instructions.
Adaptershall be installed near the equipment and shall be easily accessible.
Adapter：
The plug considered as disconnect device of adapter
Input: AC 100-240V, 50/60Hz,
Output:DC12.6V5A
Declaration of Conformity
Ying Tai Electronics Co., Ltd hereby declares that this GSMMobile Phone is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. This product is
allowed to be used in all EU member states.
The manufacturer ensures that the frequency stability of this U-NII device
can maintain transmission within the operating frequency band under all
normal operating conditions.