Users Manual

14
3.3 Cable layout and connector assembly
Connect cables to the booster’s ports after installing and fixing outside and inside
antennas.Steps as below:
（1）Open the cable package and make it bend naturally and smoothly.
（2） Keep horizontal cables straight and fasten them with a fixing clip every 1 to 1.5
meters.
（3）The cable should be bent naturally and smoothly to avoid cable damage caused by
strong pulling.
（4）RF cables should be separated from power cables; If the site condition are limited,
installing RF cables and power cables together may affect product performance.
（5）Tighten all cable connections to ensure a good contact.
（6）Offer waterproof treatment to the exposed cable ends to avoid oxidation.
（7）Finish the cable layout
At last, plug the Power Supply into wall outlet and enjoy
yourboosted cell signal!
The Specification of Boosters’Ports:
Port
Name
Port
description
DC12V
Adapter 12V
input
OUTDOOR
Base station downlink signal
reception, mobile phone uplink
signal transmission
INDOOR
Base station downlink signal
transmission, mobile phone
uplink signal reception