Users Manual

Cell Phone Signal Solutions

-19-

· The solution to different LED lights’ status:

Reason 1: There are loose or wrong connections in the repeater system.

Solution: Check that the connections between the different parts of the

system are hooked up correctly and tightl

Reason 2: The signals of other operators nearby received by outdoor antenna

are too strong. ( For example, the other operator’s signals are 10 db stronger

than the needed signals ).

Solution 1: Change the direction of outdoor antenna or its installation position,

so that the gap of signal strength is reduced between operators.

Solution 2: Use barriers ( like buildings ) to block signals of other operators.

* Connecting indoor and outdoor antennas and then power on, the signal

booster and power adapter can work normally if the LED of booster stay on

green and adapter’s LED also keep on green or red.

* If the booster’s LED are flashing in green or red, or its red indicator light stay

on without connecting any antenna, meaning that the booster break down and

please contact the Customer Service to do the replacement.

* If the power indicator is not on and the adapter can’t work, please contact

the Customer Service to do the replacement.

* Connecting indoor and outdoor antennas and then power on, but the

phone’s signal can’t get enhancement while the green or red booster’s LED

are flashing or its red indicator stay on; meaning that outdoor antennas

receive a stronger signal and the boosters stay on Overpower or Self-oscilla-

tion status. Users need to turn off the power and exclude the external faults by

yourself, then adjust the distance between outdoor and indoor antennas;

finally restart your booster.

During the process of using your Amplifier, move the Amplifier further away from

those devices if the Amplifier interferes with your radio or other electronic device.

If necessary, please contact your local dealer directly.