Users Manual

-7-
Cell Phone Signal Solutions
(8) Keep exposed Indoor cables in good order. Install pvc troughs if the exposed
cables are more than 1 meter long, and put small passive RF parts (such as power
splitter) in cable troughs.
(9) The steps about how to process the both ends of RF coaxial cables as follows:
- Keep the same redundant cable length and keep the length of stripped cables to
match the corresponding connectors.
- Use proper force to cut the jacket or insulating layers and avoid damaging the braided
shielding net and cores.
- Solder cores firmly and smoothly with a proper amount of solder, without leaving any
solder projections or nodules. Assemble coaxial cables strictly in accordance with the
installation specifications.
- Keep a moderate length for heat shrinkable tubes, and heat will shrink the tubes
evenly when adding heat shrinkable tubes to the end of cables.
- Protect the ends of cables against water and dampness. Use waterproof tape to do
waterproof treatment for exposed cable ends. Cut off the end if it is dampened or
soaked by water.
Proper antennas shall be selected according to the site conditions and requirements.
And more than one antenna can be used with the repeater, especially for repeaters over
20dBm; and 30dBm can be connected with upto 10 antennas in order to send the
signals to larger areas or distribute the signals equally.Please consult our professional
engineers about its solutions if you want to connect several antennas.
(1)Indoor ceiling Omni antenna is suitable to be installed in the center.