Assembly Instructions

22
Q4: After finishing the installation, cell phone signal is improved but c an’t make a call.
- A.Verify outside antenna is mounted correctly.
- B.Verify the location mounting outside antenna has stable signal,and confirm the
direction of outside antenna is pointed towards to the cell tower.
- C. Verify whether the local operator’s communication frequency is consistent with
booster’s frequency.
Q5: Phone calls and Inter ne t access ar e in po or quality.
- A.Adjust the direction of outside antenna and keep it point towards the
nearest cell tower.
- B.Re-route the cable from outside antenna to booster (Don't bend the cable
too much, trying to choose straight line).
-C.Veri f y the distance between outside and inside ant e nn as is over 40 feet
( Too close distance may result in self-oscillating),and there should have wall
isolati on between them.It i s rec om m end e d that ins ide and outside antenna s
don't be mounted on the same horizontal level.
Q6. Cell phone signal is improved but the coverage is unsatisfied.
- A.Adjust the angle of whip antenna.
- B.Ver ify the place mounting outside antenna receives a strong enough signal.
- C.Tighten all cable connections.
Q7. How to register the booster with Serial Number ?
Not all of consumers require to register the booster . It depends on your area
location requirement. with registration steps for your reference
Step 1: Open the following registration Link given
www.waveform.com/pages/guide-to-signal-booster-registration
Step 2: Find out mobile phone service provider that compatible with your booster.
Click and Enter
Step 3: Fill in your Location information and Booster's Serial Number,
The Serial Numberisthe FCCID,(on the label on the back of Booster unit )